Line Blocked

[ICFUC]

Hi !

VERSION=CXP1010105/4/TSWSP02/R3A

I've got a strange error.....
When dialling from node A to node B over private net to ext 36544 I get a "Line Blocked" error ( directly when finished with 5:th digit ). I can without problems dial to any other extension in that series of....36541....36542...,...36549.
Internally in node B they can call to the ext 36544 and DID works fine.
Also from node C it works without problems.
Have checked LC & NA & NU in both node A & B, but I can't find anything about 36544 in there.

If I dial the DEST for node B to place the call directly, it doesn't work either.

I'm I missing something ? I'm running out of ideeas.

 

[pcasi]

What kind of extension is 36544? Can you post the result of SUDIPIR=36544?

 

[ICFUC]

36544 is a DTS and SUSIP shows normal IDLE state.
And still there's no problem to dial internally in node B.
I'm not even shure that the call leaves the A node?
I try to send CTDEI on the ext in node A that I'm dialling from, but there isn't enough time to show anything.

 

[kank]

Is there personal number initiated for 36544?

 

[ICFUC]

Hi !
No PEN !
Thinking of restarting SLP60 on both sides, but always a lot of traffic. It seems like the user has done a FME to an ext in node A and a FME from that extension in node A back to 36544, and the extension in node A does not longer exist....
Line are probably blocked due to loopback, but I'm not sure.
Suggestions anyone??

 

[parnum]

you say you can't find 36544 in node B but it is a digital extension, and the user from 36544 in node B has a FME to an ext that does not exist in node A, and this node A extension has a FME to 36544 - but it does not exist to put a FME on? this cannot all be correct, please post susip and sudip of 36544 on node B, and dest to send call to node B from node A and C. It does not sound like your problem is to do with SLP60 but programming. Also check NUTRP;

best parnum

 

[kank]

Yes, if no PEN, it can be in NUTRP. As parnum said seems no deal with SLP60. If you think there is coordination mismatch try SFCEI first.

 

[ICFUC]

NO, have checked NU !
Also checked LC ( all TAB ) and NA.

To Parnum: I know you can't do a FME to an ext. that doesn't exist. But if you do FME over tie-line and then remove that ext. ? Node A has no knowledge about ext in node B

SUSIP and SUDIP shows OK as stated in earlier mess.
Note : it's possible to dial internally in Node B and over tie-line in Node C. The only problem exists in Node A ?? or on incoming side in Node B.