Keycodes

[gooddy]

I'm trying to apply new keycodes on to a CS 1000E Rls5.0 and for some reason the keycodes will not load.

Can anyone tell me what the procedure is the load the keycodes?

 

[bigindian65]

is it in a folder, and the ONLY data on the rmd?

Mato' Was'aka

 

[gooddy]

It is in the keycode folder but it is not the only keycode in there. I am using the software RMD with the 5.0 software so there are other files on there.

 

[bigindian65]

it doesn't like any other files on board. mov them, and it will take, then put them bck on if you want too.

Mato' Was'aka

 

[Firebird Scrambler]

The problem is because the keycode file name is too long!. Shorten the name given by Nortel to be just e.g. keycode.kcd. As stated above, make sure it's in the folder called keycode. That caught me out a few months ago!.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[bigindian65]

oh yeah, I was assuming he took off date Nortel/SID info. Good point, it still hassels me if any other data is on the drive as well.

Mato' Was'aka