I am trying to install w2k on the following configuration:
ECS P4S5MG/GL
SDRAM 512 MB
SCSI 9 Gb via adapter.
I have two problems, not sure if they are related in any way.
(1) On w2k installation there are many promprs, like "Press Enter to continue, F3 to Quit". If I press keys fast enough, like in 1 or 2 seconds, it goes ahead with installation, but if I take some time to read what's on screen, it freezes up. Why may this happen?
(2) If I am pretty prompt, the installation goes fine to the moment where it asks to remove all floppies and says that PC will be rebooted. After reboot, it says that SCSI doesn't have a boot record and starts installing from CD-ROM all over again. Why?
During the first part of installation it sees SCSI pretty well, formats it and copies files.
Comments on any or both of the issues are deeply appreciated.
ECS P4S5MG/GL
SDRAM 512 MB
SCSI 9 Gb via adapter.
I have two problems, not sure if they are related in any way.
(1) On w2k installation there are many promprs, like "Press Enter to continue, F3 to Quit". If I press keys fast enough, like in 1 or 2 seconds, it goes ahead with installation, but if I take some time to read what's on screen, it freezes up. Why may this happen?
(2) If I am pretty prompt, the installation goes fine to the moment where it asks to remove all floppies and says that PC will be rebooted. After reboot, it says that SCSI doesn't have a boot record and starts installing from CD-ROM all over again. Why?
During the first part of installation it sees SCSI pretty well, formats it and copies files.
Comments on any or both of the issues are deeply appreciated.