Hi all, need your help as i am struggling to configure ITG ISDN trunk. I followed IP trunk guides but every time when i transmit data from OTM(TM 3.0) to ITG it gets OK but after reboot ITG TN (IPTI TN of MC32) always stays "locked out".and Dchannel always stays on AEST........after every reboot of MC32 it comes up with DISABLE channel and after disabling and then enabling again channels comes in LOCKOUT state with Dchannel on AEST.
I also replace MC32 and MSDL card and also changed IPE slot but result same. it is 61c release 4.5.
I have plugged MSDL into Slot 4 of Core 0 and its cable NTND26 one end is connected to P0 of MSDL and other end is connected to PIGTAIL cable which is then connected to Port-0 of PCMCIA inserted in MC32 . In Dchannel i have set DNUM as 13 (MSDL DIP switches are set to 13). I can easily enable/disable MSDL card....
Please guide
1- Why channels always comes up in Lockout state?? what
should i check for this problem?
2- Do i have to defile MSDL card in CEQU data?? as i
remember for ITG ISDN trunk i dont have to configure
MSDL card anywhere in CEQU data, just Dchannel
programming and DNUM setting of MSDL card.
3- Data transmit always gets OK and i can see data arriving
into MC32 when i connect CLI terminal of MC32 or Telnet
MC32. I have use two LOC code 66/67 and it was also
transmitted successfully...CLAN of MC32 is connected to
customer switch. MC32 is in slot 4-1-0 and i also tried
4-1-1.
Please help how could i avoid channels lockout and why D channel wont gets Active/establish.
Regards
I also replace MC32 and MSDL card and also changed IPE slot but result same. it is 61c release 4.5.
I have plugged MSDL into Slot 4 of Core 0 and its cable NTND26 one end is connected to P0 of MSDL and other end is connected to PIGTAIL cable which is then connected to Port-0 of PCMCIA inserted in MC32 . In Dchannel i have set DNUM as 13 (MSDL DIP switches are set to 13). I can easily enable/disable MSDL card....
Please guide
1- Why channels always comes up in Lockout state?? what
should i check for this problem?
2- Do i have to defile MSDL card in CEQU data?? as i
remember for ITG ISDN trunk i dont have to configure
MSDL card anywhere in CEQU data, just Dchannel
programming and DNUM setting of MSDL card.
3- Data transmit always gets OK and i can see data arriving
into MC32 when i connect CLI terminal of MC32 or Telnet
MC32. I have use two LOC code 66/67 and it was also
transmitted successfully...CLAN of MC32 is connected to
customer switch. MC32 is in slot 4-1-0 and i also tried
4-1-1.
Please help how could i avoid channels lockout and why D channel wont gets Active/establish.
Regards