Issue with 2nd E2t Card on MXe

[cknipe]

Hi,
I bought an Mxe expansion kit a while back that came with and echo cancellor and a 2nd e2t card. No matter what I do I cannot get that 2nd card to show up in the system hardware compute cards form. No matter what I do it slot 2 show not recognized. I tried the same card in slot 2 of another mxe and recieved the same thing. But heres the fun part, when I take that same card and put in in slot 1 of either controller, it works. So i'm thinking it must be my programming.
I added dhcp option 66 and entered the address of the mitel system.

Then added option 67 with a value of /sysro/E2T8260/
After that I added the mac address in as a static reservation.

That didnt work either. While I had the card working in slot 1, I programmed it via the bootChange command to add a unique IP address to it. Again, it worked just fine with the new ip address in slot 1, but then after moving back to slot 2, I get Not recognized.

Anyone notice anything that could be the problem?

 

[kwbMitel]

I don't bother with DHCP

Try Hard Coding the E2T - Here's a How to:

https://www.yousendit.com/download/dXFVblFBMm10d0h2Wmc9PQ

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.

 

[IrwinMFletcher]

Telnet into port 2007 and see what it's doing. It needs to boot before it can display the data in ESM.

 

[cknipe]

turns out I had the flag wrong on the 2nd card. it was set to 0x4 rather than 0x0

 

[kwbMitel]

Did you get that from my attached file?

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.