ISDN Line not connecting to IPO

[louis1965]

Hi all

I have a IPO 500 V2, with 6 BRI's connected.
)ne line is not connecting and the following reflects in sysmon.

any help would be appreciated.

2365000810mS ISDNL1Tx: v=7 peb=7
0000 02 01 01 2b ...+
2365001018mS ISDNL1Rx: v=7 peb=7
0000 02 ff 03 08 01 01 05 a1 04 03 90 90 a3 18 01 89 ................
0010 1e 02 82 83 ....
2365001019mS ISDNL2Rx: v=7 peb=7
0000 02 ff 03 08 01 01 05 a1 04 03 90 90 a3 18 01 89 ................
0010 1e 02 82 83 ....
2365001019mS ISDNL3Rx: v=7 peb=7
ISDN Layer3 Pcol=08(Q931) Reflen=1 ref=01(Remote)
Message Type = Setup
InformationElement = Sending Complete
InformationElement = BearerCapability
0000 04 03 90 90 a3 .....
InformationElement = CHI
0000 18 01 89 ...
InformationElement = PI
0000 1e 02 82 83 ....
2365001042mS ISDNL1Rx: v=7 peb=7
0000 00 85 73 ..s
2365001042mS ISDNL2Rx: v=7 peb=7

 

[IPGuru]

Is the light on the NTE lit?
Have you tried checking the circuit with an ISDN Tester?

Tip - it is almost always a fault with the ISDN circuit


A Maintenance contract is essential, not a Luxury.
Do things on the cheap & it will cost you dear

 

[louis1965]

Thanks IPG,

The issue was isolated to the port on the card.


Regards