Just installed an IP Office 500 with Embedded VM and I cannot get the Visual Voice to prompt the user for a password. Here's the pertinent info...
- Phones: 4610 (H323 exts)
- System > "Message button goes to Visual Voice" is checked.
- Voicemail tab under each User has a voicemail code
- Each User's Source Number tab has a "Vxx" (eg: V10 for ext 10) entry. I read that having this entry causes a "trusted source" problem but I removed this entry for testing purposes and still was not prompted for a password.
I also tried using the default short code of *17 to access the VM and I'm not prompted for a password there either.
At other locations I have gotten this to work and I have looked at everything relevant setting I can imagine in those configs and mirrored as much as I can to the IP Office in question but still no luck.
Any ideas? Thanks!
- Phones: 4610 (H323 exts)
- System > "Message button goes to Visual Voice" is checked.
- Voicemail tab under each User has a voicemail code
- Each User's Source Number tab has a "Vxx" (eg: V10 for ext 10) entry. I read that having this entry causes a "trusted source" problem but I removed this entry for testing purposes and still was not prompted for a password.
I also tried using the default short code of *17 to access the VM and I'm not prompted for a password there either.
At other locations I have gotten this to work and I have looked at everything relevant setting I can imagine in those configs and mirrored as much as I can to the IP Office in question but still no luck.
Any ideas? Thanks!