Ipecs SIP

[rsatech]

Can anyone assist with info on how to setup 2x Ipecs with SIP connection. If anyone has documentation please let me know.

Thank you in advance

 

[xs650]

Which Ipecs do you mean exactly(LIK, MG, CM, SBG or eMG80)?

For a network between two LIK.

SBG and eMG80 are very similiar like LIK but I don´t know CM and MG....

regards
xs

 

[rsatech]

They are both LIK Ipecs 100 .

 

[nfcphoneman]

What exactly are you trying to do? Network two systems together?

http://www.jacksonvilletelephone.com

Jacksonville Florida Telephone Systems

 

[rsatech]

Yes, I am trying to network 2x systems together by using SIP and not H323 protocol. In default the LIK uses H323, what should I do in the case where SIP protocol is required?

 

[xs650]

I have made a quick test and it is possible when you use sip trunking in PGM133.

I have used:
Proxy server: IP of the other LIK
Use outbound proxy: ON
Domain: IP of the other LIK

I have only tested basic call cause I am not sure where this makes sense...
Good luck

 

[rsatech]

Thx xs650, that works, any ideas what to do, since I have 4x different sites that need to be connected this way, and I need to share all channels among them.

 

[xs650]

I think there can be different ways.
One way is:
-put the co lines in 4 different groups
-point the co lines via the ip address to the other sites
-dial the co access code to reach the other sites

 

[deandiamond]

if you get the network liecense keys one foreach system you can set it up that way then the voip trunks on each site will onlt get used if it makes a call across.
takes 10 mins to programme its all under networking pgm's