Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ipecs SIP

Status
Not open for further replies.

rsatech

Programmer
Sep 5, 2013
30
ZA
Can anyone assist with info on how to setup 2x Ipecs with SIP connection. If anyone has documentation please let me know.

Thank you in advance
 
Which Ipecs do you mean exactly(LIK, MG, CM, SBG or eMG80)?

For a network between two LIK.

SBG and eMG80 are very similiar like LIK but I don´t know CM and MG....

regards
xs
 
Yes, I am trying to network 2x systems together by using SIP and not H323 protocol. In default the LIK uses H323, what should I do in the case where SIP protocol is required?
 
I have made a quick test and it is possible when you use sip trunking in PGM133.

I have used:
Proxy server: IP of the other LIK
Use outbound proxy: ON
Domain: IP of the other LIK

I have only tested basic call cause I am not sure where this makes sense...
Good luck
 
Thx xs650, that works, any ideas what to do, since I have 4x different sites that need to be connected this way, and I need to share all channels among them.
 
I think there can be different ways.
One way is:
-put the co lines in 4 different groups
-point the co lines via the ip address to the other sites
-dial the co access code to reach the other sites
 
if you get the network liecense keys one foreach system you can set it up that way then the voip trunks on each site will onlt get used if it makes a call across.
takes 10 mins to programme its all under networking pgm's
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top