IP Office with KIRK

[abbof]

Hi
I have to connect an ip office 8.1 with a KIRK DECT system, such licenses do I install on ip office and how to configure it?

 

[FlyinScotsman]

No Licenses needed, the Kirk Dect 500 is a programmable base station with 8 ports and all you need to do is run a cable from the IPO analog station ports and connect them into the base station. You will need the CCFP Administration programme to create users and the menu on the dect phone to register individual users.

 

[FlyinScotsman]

try this, you will also require an RJ45 end to a 9 pin serial plug

http://support.polycom.com/PolycomS...upport/voice/dect/previous_KIRK_software.html

 

[FlyinScotsman]

this is the link for the user manual

http://www.jct.com.au/downloads/20070807135005.pdf

 

[hairlessupportmonkey]

Erm,

Is it the old 500 or the new 6000 SIP based?

The 500 is Analogue....

the two are very different, but use the same handsets.

What Kirk Dect are you planning to install?

ACSS - SME
General Geek

 

[abbof]

Hi
the system KIRK and 'server KWS6000 and I have to plug it in with sip ip office

 

[hairlessupportmonkey]

So you will need 3rd Party SIP endpoint licences for each handset you register.

I am not prepared to tell you how to configure it here. However if you need a business partner to install it then someone here in your region should be able to assist for a fee.

ACSS - SME
General Geek

 

[hairlessupportmonkey]

BTW - Ive done a few KWS6000 and they have their quirks, but for the most part installation is fairly easy.

ACSS - SME
General Geek

 

[abbof]

thanks for the information