IP Office 406 1

[greywolf123]

I'm setting up a new IPOffice and need help setting up the circuit. I familiar with the programming of the IPO other then the circuit because the first IPO was
Installed for us so if anyone could give me some direction I would appreciate it…



Service Is: New
Dedicated Service Product: OneConnect Voice & Data(39117014)
Number of Voice Channels: 8
Number of Data Channels: 12
Number of T1's Ordered: 1 of 1
Number of DID's: 20
Local Number Portablity: No
Current Local Carrier: N/A
Previous Carrier: N/A
Expedited Data Order: No
Expedited Voice Order: No

T-1 Circuit Configuration
________________________________________
Circuit Configuration:
Framing: ESF
Configuration: 4-Wire
Jack Type: RJ-48X
Line Coding: B8ZS
Fail Safe Routing: N/A

Signaling/Pulse Information
Signaling: DT(DTMF)
Trunk Start Signal/Pulse: Wink
ISDNProtocol (PRI Only):

Customer Owned Equipment Information
CPE Type: P
Model: IP OFFICE
Manufacturer: AVAYA
Number of Digits for
PBX Extension Numbers: 4
Hunting Arrangement: Ascending Sequential
Inbound to PBX Start
Dial Signaling: N/A
Outbound to PBX Start
Dial Signaling: N/A

SPECIAL NOTES AND ADDITIONAL SPECIFICATIONS
________________________________________
DIGITAL ONECONNECT. DIGIT RESTRICTION ON 4TH DIGIT NO 0/9 XXX-XXX-4XXX. CUSTOMER IS OWN VENDOR.



Thanks in advance

Owen

 

[phonetechgal]

Reply with phone number to call. I'll assist you.

 

[greywolf123]

Thanks phonetechgal 224-217-6020


Owen