Ip office 406 in constant reboot

[Birdy213]

I was upgrading a 406 form 3.2(67) to 4.1(15) and the system went into a constant reboot. I realized why it did it, i had all the phone still plugged into the expansion modules and the all the phones were trying to download new firmware at once. I changed out the 406 and now im trying to dte the bad 406. I open hyperterminal and adjust the settings, but when i go to power up the unit and hit the esc key my laptop turns off. Any reason why?

 

[amriddle01]

Try another laptop/pc, if that does it your 406 is really screwed. If not I guess it's your laptop

ACS - IP Office Implement

 

[amriddle01]

Leaving the handsets plugged in does not cause that either, they just Queue for the download slots, have done it a few times.

ACS - IP Office Implement

 

[Birdy213]

What whould have caused it then

 

[amriddle01]

Not sure my crytsal ball is in for repair at the mo...lol , seriously though if that was the cause it's the first I have seen.

ACS - IP Office Implement

 

[TomMills]

yeah, i have done loads of upgrades, never unplugged the phones. like amriddle says, they just queue,

 

[tlpeter]

Maybe it was a 406v1 or a 406v2 pcs7 or lower with not enough memory


ACA - Implement IP Office
ACS - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!

 

[Birdy213]

its a 406 v2 pcs 11

 

[tlpeter]

Was your pc set with a static ipadres,firewall of and no virus scanner ?
Where you connected directly or true a switch ?

Did you maybe uncheck "validate" when you did the upgrade ?

It looks like you did that and then it erases the software and then it needs an bootp entry(is there after pulling the config) and a tftp server (manager) running

ACA - Implement IP Office
ACS - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!