Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

IP 500 V2 - Switched from E&M to PRI but not working

Status
Not open for further replies.
Bhutson

Bhutson

IS-IT--Management
Jan 29, 2008
15
US
Switched the programming from the T1 E&M to a PRI. Pretty much a default PRI setup - NI2, ESF/B8ZS, 4 digits. In system status the line shows in service and idle, but no calls in or out. The provider says the B Channels are going up and down, but I don't see that in system status.

Any ideas?
 
Sort by date Sort by votes
The provider thinks it may be a device between their switch and the customer that is set to the wrong signaling. They have a tech on route to check it out.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

4thright
  • Question
IP Office 500 v2 - T1 Trunking
Replies
14
Views
564
derfloh
derfloh
timbreck
  • Question
Connecting avaya ip office 500 v2 to a valcom page system 1
2
Replies
26
Views
1K
timbreck
timbreck
telecomgear
  • Question
Working IP Office 500 v1 4.2 suddenly cannot dial out on PRI. Call come in fine.
Replies
8
Views
551
telecomgear
telecomgear
tetratech
  • Locked
  • Question
IPO 500 V2 software details
Replies
3
Views
198
sizbut
sizbut
Bist rajendra
  • Locked
  • Question
Avaya Ip office PRI Incoming OK but Outgoing not working
Replies
1
Views
135
IPOTS
I

Part and Inventory Search

Sponsor

Back
Top