IP 500 IP Routing

[Bibbyboy]

I have a 500 processor on 4.2 software and its IP is on the voice network 192.168.240.X, and the data is 192.168.140.X. I've made the Second LAN on the Data network, and of course the computers can communicate with the processor now, but can I make some kind of route in the IP office so that people can access the voicemail machine as well? I know I can probably get a route put in on the PIX here, but I wanted to know if I could do it through the IP office.

 

[Bas1234]

on the PC do a "route add"

Start > Run > typ CMD (press enter)

typ;

route add 192.168.240.0 mask 255.255.255.0 192.168.140.X -p

The X is the ipo address, -p is to make it permanent.

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________

 

[Bibbyboy]

when I try to add that route it tells me that it cannot do that because the gateway does not lie on the same network as the interface. I put an IP route in the IP office from 192.168.240.2 (voicemail machine) and destination LAN2, but still no luck

 

[Bibbyboy]

nvm that last post, I was doing that step on the voicemail machine rather then the machine I was trying to get to access the voicemail machine. Okay, Heres a new question, can I get the voicemail machine to communicate with the data network to access the internet via the IP office, or is that something that will need to be input into the PIX

 

[baldwincl]

how did i not know about that??

 

[Bas1234]

For the PIX i think better not!
Put a second lan port if you have 1 left on the same VLAN as the IPOffice and create routes in the pix, this is the best way i guess or let it connect on the data vlan.

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________