Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Internal Transfered calls being dropped on 6.1XC MICS

Status
Not open for further replies.

RoeKoe101

Vendor
Mar 16, 2006
9
US
Have a MICS 6.1XC with PRI.
About 10% of the calls are being lost when transfered from the receptionist to an internal extension.

It happens on SAME receptionist phone to different extensons.
It has been confirmed it is not user error.
Are there settings that possibly could effect this either with the circuit OR switch. I do not believe that the receptionist phone has been switched out that was going to be my next step.
 
any errors on the PRI?
probably the calls are getting dropped

Do you have the latest 6.1? (SP ending in G10)
 
The software is acctually 6.0 - 30BwE02 NAT
I found a few Network Event Logs that all happened yesterday. I spoke with the customer today and they have not had any reported troubles. If you have any information it would be greatly appreciated.
EVT 336-00
EVT 372-00
ALM:44-0
ALM:75
 
Try replacing the cable from the telco d mark to the pri csu, use a cat5 cable, this has fixed the errors before, especially alarm 75.
 
6.0 = bad
6.1 ver 6.10 = good

"There are those who would make you believe there are no choices left.That they have the last word and its final.To those who try the world is wide open choices many.To those who dont only death awaits you.
 
We had the carrier bounce the T1 and we have had no problems for 3 days. The patch cable was changed out a while ago. If the problem persists we will upgrade the software.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top