integration between hipath 4000 and openscape business uses E1 / DIUN2 and DIUT2

[slamet riyadi]

does anyone have document integration between hipath 4000 and openscape business using E1 / DIUN2 and DIUT2

 

[adibv]

As far as I know it works only over IP.

 

[Moriendi]

TDM Cornet-NQ connection was always supported from 4K to 3K, and situation is the same with Openscape Business. Should work OK.

 

[slamet riyadi]

Hai @Moriendi
Do you have the installation guide document. I still have a problem, I didn't detect cornet, but I detected CO trunk and the sound didn't come out, just ringing ...

 

[thepfy]

Is the trunk up on both systems, with the same protocols?
For some types one end needs to be set as a Master and one a Slave (DPNSS which I think Cornet-NQ is).
Have you done any tracing to see what is being sent over the trunk when you place a call?

Routing and not ringing make me think it may not be routing to where you expect....

 

[slamet riyadi]

@thepfy thank you for the information ... it has gone well.


@gunwan arief ... mohon maaf pak..untuk AP1 sudah clear semua... dan ini bukan untuk AP1. mohon dipertimbangkan lagi sebelum bertanya..terima kasih

 

[gunawan arief]

mohon maaf kalau gitu pak slamet, saya pikir msh thread sebelumnya dan saya hanya bertanya