Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

integration between hipath 4000 and openscape business uses E1 / DIUN2 and DIUT2

Status
Not open for further replies.

slamet riyadi

Technical User
Sep 30, 2019
5
ID
does anyone have document integration between hipath 4000 and openscape business using E1 / DIUN2 and DIUT2
 
As far as I know it works only over IP.
 
TDM Cornet-NQ connection was always supported from 4K to 3K, and situation is the same with Openscape Business. Should work OK.
 
Hai @Moriendi
Do you have the installation guide document. I still have a problem, I didn't detect cornet, but I detected CO trunk and the sound didn't come out, just ringing ...
 
Is the trunk up on both systems, with the same protocols?
For some types one end needs to be set as a Master and one a Slave (DPNSS which I think Cornet-NQ is).
Have you done any tracing to see what is being sent over the trunk when you place a call?

Routing and not ringing make me think it may not be routing to where you expect....
 
@thepfy thank you for the information ... it has gone well.


@gunwan arief ... mohon maaf pak..untuk AP1 sudah clear semua... dan ini bukan untuk AP1. mohon dipertimbangkan lagi sebelum bertanya..terima kasih
 
mohon maaf kalau gitu pak slamet, saya pikir msh thread sebelumnya dan saya hanya bertanya [smile]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top