Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

init g3siv7 1

Status
Not open for further replies.
chris5225

chris5225

Programmer
Mar 7, 2011
68
US
I have a g3siv7 including the init login and passcode (not defaulted) This is a working switch. Can somebody advise me how to not screw up everything when i go in to Cha-sys-par-cust-op.just to add some features.
Thanks
Chris
 
Sort by date Sort by votes
Not a big deal Chris....log in make your changes and then from command line enter "newterm" and follow instructions...all will be fine....it's just like any other login except after making changes you have to log out and then back in for changes to take effect...
 
Upvote 0 Downvote
Thanks wellco9530. I did it and works like you said. I never used the init before on a working switch. THANKS so much.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

youthtelco
  • Locked
  • Question
early RTP issue? Cutting first few digit at the initial incoming call.
Replies
0
Views
86
youthtelco
youthtelco
ITHawkDriver
  • Locked
  • Question
MM710B stuck initializing
Replies
2
Views
46
ITHawkDriver
ITHawkDriver
wpetilli
  • Locked
  • Question
G450 - NVRAM Init
Replies
3
Views
118
wpetilli
wpetilli
fondog2
  • Locked
  • Question
G450 nvram init no GIW from services port
Replies
4
Views
69
fondog2
fondog2
avAyATEKky
  • Locked
  • Question
SBCE Initial setup 2
2 3 4
Replies
73
Views
351
JuanAvaya
JuanAvaya

Part and Inventory Search

Sponsor

Back
Top