xtremetoonz
IS-IT--Management
We are trying to get inbound DID routing working to a Multi-Tech Faxfinder. The issue we are having is getting the DID to route to an extension list. It seems, no matter what we do, the incoming call is begin routed to the line card open hours default ext set in the line card properties. We are able to set up the DID as a normal incoming DID and route to an internal extension, just not an ext list. The lec is sending 7 digits. Below is our dial plan specific config for this:
Table Create 2 Incoming 4 Digit DID and Auto At
/ Id Entry Digits Min Max Class Prio Route
/ -- ----- ------------ --- --- ------------- ---- -----
TableEntry Create 2 8 NXX5036 7 7 Internal 0 12
TableEntry Create 2 9 NXX5037 7 7 Internal 0 12
/ Route Description
/ ----- -----------
DestinationRoute Create 12 FaxFinder - Inbound
/ Route Entry DestinationExtension
/ ----- ----- --------------------
DestinationRouteEntry Create 12 1 *0010
Of course I've eliminated unnecessary lines from these configs. Extension list *0010 has two idle analog line card ports. When we dial the number from outside we get the main auto attendant verified by looking at the status of the digital line card. 7 digits in, showing the caller ID and begin sent to 5501 (main AA). I suspect the issue is with the syntax of the Table Create 2 Incoming lines but not sure. Help anybody?
Table Create 2 Incoming 4 Digit DID and Auto At
/ Id Entry Digits Min Max Class Prio Route
/ -- ----- ------------ --- --- ------------- ---- -----
TableEntry Create 2 8 NXX5036 7 7 Internal 0 12
TableEntry Create 2 9 NXX5037 7 7 Internal 0 12
/ Route Description
/ ----- -----------
DestinationRoute Create 12 FaxFinder - Inbound
/ Route Entry DestinationExtension
/ ----- ----- --------------------
DestinationRouteEntry Create 12 1 *0010
Of course I've eliminated unnecessary lines from these configs. Extension list *0010 has two idle analog line card ports. When we dial the number from outside we get the main auto attendant verified by looking at the status of the digital line card. 7 digits in, showing the caller ID and begin sent to 5501 (main AA). I suspect the issue is with the syntax of the Table Create 2 Incoming lines but not sure. Help anybody?