Impossible to change vlan ID in system IP properties on MXe in MCD4.2

[Layne5]

Hi,

When changing the VLAN id from 1 to 3, the MXe asks to reboot.
After reboot, VLAN is on 1 again.
To be sure,I also tried RTC shell command vlan_on but no change.
Did anyone notice the same?

(i know there are other/better solutions but the customer really wants the tag on the controller!)

Thnx!

 

[kwbMitel]

I prefer to connect the 3300 to a switch port that is dedicated to the VLAN rather than tagging the packets from the 3300. This way, in an emergency or for troubleshooting, you can direct connect to the 3300.

I have yet to enable VLAN tagging on the LAN port of the 3300.

**********************************************
What's most important is that you realise ... There is no spoon.

 

[LoopyLou]

Have not tried it on 4.2

The single biggest problem with communications is the illusion that it has taken place.