How to tell if I need another PRI

[Highlights]

ON a BC50 system I am able to actually look at an active system status and see all 23 channels, calls in progress etc. Is there any way to see these stats on a MICS 7.1 XC so that I can tell if I am going to need another PRI? The only metrics I see are the Hunt Groups. I am mainly looking for when the PRI channels become ALL BUSY for incoming or outgoing traffic.

 

[curlycord]

MICS too primitive for that
You can ask your carrier to give you a traffic study.



________________________________________

Add me to LinkedIN

**New Allworx Forum**

=----(((((((((()----=

http://www.curlycord.com

Toronto, CAN

 

[Highlights]

Thanks!

 

[cook1082]

Usually if you get complaints of busy signals and no free lines then that would tell you all channels are being used.

 

[allworxguy]

You can setup an M7324 with Appearances of all 23 channels and observe activity. LINE001-023.

Marv ccna

 

[curlycord]

Marv I was thinking about that but was going to suggest another phone at reception for that but for the cost of doing that vs a study was close.
Ms Whiggins without the features might be disastrous.



________________________________________

Add me to LinkedIN

**New Allworx Forum**

=----(((((((((()----=

http://www.curlycord.com

Toronto, CAN

 

[exsmogger]

Unless I'm missing something I thought PRI channels couldn't be assigned as line appearances, only target lines.

Brian Cox
Georgia Telephone

http://Georgia-Telephone.com

http://www.linkedin.com/in/briancox1952

 

[curlycord]

Only on older software it seems like 4.1.






________________________________________

Add me to LinkedIN

**New Allworx Forum**

=----(((((((((()----=

http://www.curlycord.com

Toronto, CAN

 

[exsmogger]

Thanks.

Brian Cox
Georgia Telephone

http://Georgia-Telephone.com

http://www.linkedin.com/in/briancox1952

 

[Highlights]

I tried to assign the lines to a set as suggested but I get an error that says: "PRI LINES CAN NOT BE ASSIGNED TO SETS

 

[curlycord]

We already stated your software was to new for that per above.

Did you call the carrier yet?



________________________________________

Add me to LinkedIN

**New Allworx Forum**

=----(((((((((()----=

http://www.curlycord.com

Toronto, CAN