Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How can i setup 2 T1 links with loadbalnce and redndancy in Nortel

Status
Not open for further replies.

ciscomeo

Technical User
Jun 9, 2003
94
US
My objective is to activate 2 T1 links (each with different service provider) from site A to site B and at the same do load balance and time activate redundancy (incase link 1 goes one link2 should still be working).

How can i configure and do this in a Nortel router SR1004?

Thank you,

Erle
 
Part Number SR2101024

Description
Secure Router 1004 2-ports active T1 VPN Bundle, (2) 10/100 Eth. Ports, 32MB FLASH, 256MB SDRAM, AC power supply, OSPF, RIP, VLAN , BGP, Firewall, Multilink, VPN, Multicast, Qos

MSRP
4,390

If you are looking for configuration information, you can retrieve documenation here:
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top