Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

HD 2 Mirroring problems

Status
Not open for further replies.

Tech guy 297

Technical User
Jan 3, 2024
18
0
1
AW
Hi Guys, I'm just insert a new HD 2 in bay 2 slot, and the HD begin with the mirror proces, i get this following when i insert the redundant status command, everything looks good, but after passing 75% of mirror proces i get the following error that "Source caused rebuild failure."

this is the first redundant status:


RAID controller rebuilding : 71% complete. 20 minutes remaining.

Hard Disk Disk
Disk Installed Fault State Status
---- ----------- ----- ------- ------
1 Yes No Normal Match.
2 Yes No Rebuild Match.

Disk 1 id matches
Current Model Number : ST9160314AS
Expected Model Number : ST9160314AS
Current Serial Number : 6VCY4EE4
Expected Serial Number: 6VCY4EE4

Disk 2 id matches
Current Model Number : ST9160314AS
Expected Model Number : ST9160314AS
Current Serial Number : 5VC35AD0
Expected Serial Number: 5VC35AD0

--------------------

Everything was looking good but after 5 minutes i cheked once again and i get this error:

SATA RAID Controller

Hard Disk Disk
Disk Installed Fault State Status
---- ----------- ----- ------- ------
1 Yes No Normal Match.
2 Yes Yes Bad Source caused rebuild failure.

Disk 1 id matches
Current Model Number : ST9160314AS
Expected Model Number : ST9160314AS
Current Serial Number : 6VCY4EE4
Expected Serial Number: 6VCY4EE4

Disk 2 id mis-match
Current Model Number : Not Applicable
Expected Model Number : Invalid
Current Serial Number : Not Applicable
Expected Serial Number: Invalid

--*-*--
 
7147962a-b7ce-4bbf-b335-fdde845af006_cmvtku.jpg
dcc334ec-28a6-4af4-b0fa-ba151dd7c945_ujcx9k.jpg
 
its very finicky we always obrtain 2 identical new drives
take backup clear raid sockets restore backup to 1st drive then rebuild the array

have to have an outage but when 1 drive dies the other is probably not far behind

If I never did anything I'd never done before , I'd never do anything.....

 
Try clearing the HD ids. Remove both drives, power cycle the controller wait until both leds flash, power down, insert drives and power up. Your mirror should complete without error.

I suppose you're entitled to your opinion, I'm just not going to suppose very hard.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top