Hardware install

[JCCDM]

Afternoon All,

Trying here as I've been looking a while. Controller is a MXe 3300 III

I have a spare controller (currently no setup) that I need to add a few cards and bits and pieces back into. I am about to put the 128 channel version echo canceller in there am trying to confirm the correct spot. I can't find it on the technicians handbook but on the help files on the controller, there is a section that talks about MMC slot for the AX controller.

My question is, can I use the MMC specifications from the AX instructions for my MXe setup? eg. can I just put the card on same MMC slot as I would if it was an AX.

Cheers.

Justin.

 

[Billz66]

Dont think it matters what slot - normally use the ones without openings at the front for cards that dont need them ,
the data will be in the technician handbook

If I never did anything I'd never done before , I'd never do anything.....

 

[SXWizard]

MMC 5 or 6 would be the choice for an echo chancellor on an MXe III. Doesn't matter which one.

 

[JCCDM]

Thanks for the advice guys, I will put it into 5 or 6 today.

Cheers, Justin

 

[Lundah]

System will auto-detect it, along with DSP modules. 5 or 6 would be best since it doesn't need to be on the front face of the controller, but any available slot will work.