H323 Trunk between IPO & BCM450

[serajeg]

I have a customer with an existinb BCM450 R6.0 & IP Office R9.0.
the BCM has a VOIP gateway lices & the IPO has a VCE networking license & we need to connect them via H323.
now calls from BCM to IOP going fine but calls from IPO to BCM does not go out.
in the IPO I set the suppelmentary services to H450 & in the BCM I set the trunk type to IPT.
the IPO SC config is:
8N;
Dial
N
5
in the BCM, I set the target line for the incoming digits & assigned it to a digital set.

Any Idea why I could not reach the BCM from the IPO?
BR,
Seraj

 

[Okkie26]

can you run system status and check line 5 to see if the line is being used when ypu try to dial to the BCM?

 

[chrisag]

I have connected an ipo with a BCM450 but it was with sip trunks, I don't know if you will
be able to work it out with h323.
Anyway change the h323 trunk from IPT to other and change the H450 as this is not supported in BCM.
Also how did you configure the BCM as private network or public.

 

[serajeg]

I ran the SSA & the lines ar not used when dialing from IPO to BCM.
I configured the BCM network to both public & private with now change.
I will change the h323 trunk to IPT but for the IPO should I change the supplementary to none?

 

[Okkie26]

I think QSIG is what you need..

Also, since you cannot see any activaty on the trunk, chack the routings..

 

[chrisag]

Change the H323 trunk to none not IPT.
Also change your short codes

8XXX it depends on the length in BCM
Dial
.
5

 

[serajeg]

I tried QSIG with no success
Chrisag,
I will try this next Monday & get back to you.

 

[madwok]

I had better luck in setting with SIP trunk between IPO and BCM.