testLED, yes, you will get a "general failure", just wait about 10-15 minutes before you call it a failure, I have been getting this behaviour ever since FW048, I get it on every upgrade, yet given enough time the MM710B will upgrade and reset itself, and be fine...
This is what I get guys. This time I used the internal address. I left it over night last night to see if it would upgrade on the customer address but still on FW 45. I will check it again in an hour to see if it has worked on the internal address but i have my doubts.. Just to advise I have also tried to carry this out while the board was busied out and when not to see if this would make a difference.
"To download firmware onto the media module, follow instructions
in the "Upgrading / Downloading Software / Firmware" section of the
Installation documentation."
PLEASE NOTE: To ensure a successful download, from the SAT or ASA issue the command
'busyout board V#' before issuing 'copy tftp' command. Upon completion, from the SAT or
ASA issue the command 'release board V#'.
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
36 years Bell, AT&T, Lucent, Avaya
Tier 3 for 26 years and counting
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.