I have 2 standalone sites with a QSIG trunk between for 4 digit dial. I call fwd extension in site A to an extension in site B (4 digits). coverage after fwd'ng is set to n which means to terminate at the site B side. The call fwd's, rings on the other end, but doesn't not follow coverage to VM and just gets RNA. If you fwd over pstn it works. Any ideas on what setting this must be. I'm assuming this would be on the TG.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fwd over qsig
- Thread starter btrain08
- Start date
Having the same problem. It appears to be a bug in the Avaya though, not a setting. When you do a trace and the remote phone tries coverage it says "coverage path 0 point 0". I am CM 4.0.5 SP1 (and last I talked to Avaya SP1 was supposed to fix it - NOT). I have a new ticket open with them and will let you know what they say this time.
- Status
Similar threads
- Locked
- Question