FTP to VAL Board

[FicBen]

We are CM 3.1.1 and I'm needing to backup our VAL board. I've tried the 'enable filesystem board login' command but it tells me to use enable filexfer. I entered this command and noted that it requires no login information. How do I set the login information for getting to the VAL board?

I've also loaded an old version of VAL Manager, 1.0.104 and it gave the error message 'IP_interfaces is an invalid entry'. I'm guessing I need to upgrade VAL Manager.... am I correct?

 

[Zen216]

i just went through this.. lol
enable filex
then enter the info, login, pw and board location...
there is also a FAQ on ftp to val board...
faq690-6278

and Mikey's faq faq690-5977

(if you get error secure ftp not supported, you need firmware upgrade, or you can use regular ftp. If you need to upgrade firmware see my post.. thread690-1339612 )

here is a screen shot of the enable file transfer screen..

enable filexfer Page 1 of 1


ENABLE FILE TRANSFER

Login:
Password:
Reenter Password:
Secure? y
Board address:






Hope it helps

 

[FicBen]

Yes! THANK YOU!

 

[td1031]

Mine doesnt support secure ftp so i have to change the secure option to n....

Just an FYI in case you run into that