Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

FTP to VAL Board

Status
Not open for further replies.

FicBen

Technical User
Nov 19, 2004
124
US
We are CM 3.1.1 and I'm needing to backup our VAL board. I've tried the 'enable filesystem board login' command but it tells me to use enable filexfer. I entered this command and noted that it requires no login information. How do I set the login information for getting to the VAL board?

I've also loaded an old version of VAL Manager, 1.0.104 and it gave the error message 'IP_interfaces is an invalid entry'. I'm guessing I need to upgrade VAL Manager.... am I correct?
 
i just went through this.. lol
enable filex
then enter the info, login, pw and board location...
there is also a FAQ on ftp to val board...
faq690-6278

and Mikey's faq faq690-5977

(if you get error secure ftp not supported, you need firmware upgrade, or you can use regular ftp. If you need to upgrade firmware see my post.. thread690-1339612 )

here is a screen shot of the enable file transfer screen..

enable filexfer Page 1 of 1


ENABLE FILE TRANSFER

Login:
Password:
Reenter Password:
Secure? y
Board address:






Hope it helps
 
Mine doesnt support secure ftp so i have to change the secure option to n....

Just an FYI in case you run into that
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top