Can you use the same DID's for all systems in an SCN, or do I need different numbers for each site? I have 1 site with a PRI and 3 or 4 with just analog lines. I know I can setup different DID's for the remote sites, but should it work with the same numbers? Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
FNE Codes Across SCN 1
- Thread starter bluemr2
- Start date
You need different DIDs
IP Office remote service
IP Office certificate check
CLI based call blocking
SCN fallback over PSTN
IP Office remote service
IP Office certificate check
CLI based call blocking
SCN fallback over PSTN
-
1
- #3
It works with the same DID, the problem is that you need to route the call to the FNE code on the system where the user is located.
This would mean that you need to use CLI routing for users that are on a different system than the DID.
"Trying is the first step to failure..." - Homer
This would mean that you need to use CLI routing for users that are on a different system than the DID.
"Trying is the first step to failure..." - Homer
- Thread starter
- #4
- Status