ferrograph 22

[MeVersion5]

Having issues configuring the rs485 serial port to talk to the wallboard after installing new serial card. Anyone know the required setup for the card, dip switches etc...

 

[crashtest1000]

Ge the CCC install manual its on

http://marketingtools.avaya.com/knowledgebase/

 

[MeVersion5]

not enough info dude

 

[intrigrant]

Quote:
"not enough info dude"

You're not very friendly to a person who wanted to help you.

Maybe you had a bad day?

If not then don't look at this doc:

http://marketingtools.avaya.com/knowledgebase/index/techuk/ccm/ccm3/ccminuk.pdf

It's on page 17

 

[MeVersion5]

I meant not enough info in the ccc docs, your one has the requirements for the advantech card, I have a usb serial hub

 

[Escorthosis]

I think the usb to serial hub is just an ordinary RS232 serial device. These are used to connect only one RS232 device to a PC or laptop.

The Wallboards use the RS485 protocoll. RS485 is also serial but different: more devices can be connected (daisy-chained) to the same bus but are addressed using a devicenumber.
So thats why the CCC/CCM Servers are equiped with an extra Advantech RS485 board on top of the two existing RS232 comports.

 

[MeVersion5]

The usb hub has dip switches which allow you to select the mode of operation for each port,232/422/485... also have a single usb serial converter which is configured thru the software, just having a few issues getting the right settings on the switches