Ethernet# 3 is not detecting the speed

[sawadallah01]

Hello all,

I had configured the ip interfaces for S8510 Media Server. Both Ethernet 0 and Ethernet 3 which they were they dedicated for Control Network, and (Customet Network & Processor Ethernet)respectively have been configured for 100MB and Full Duplex. Only, the control network speed was detected after connecting the LAB TOP to it using the cross over cable. I have did the same for Ethernet 3, but it is still not detecting the speed and duplex. After I set the speed and duplex and click submit, it returns back to (no speed detected) mode, and even it is not giving me any speed or autosence.
Restarting the server did not rectify the issue.

Any workaround?


Kind Regards,
Salama Awadallah
Telecom Engineer
Future Technology-Dubai

 

[kpearlt3]

sawadallah01 did you try setting the speed and duplex using the setnic command? From Linux just run setnic -m 100F eth3.

 

[sawadallah01]

I did that command, but it is still the same.
(The spped & duplex are still unkown).

Kind Regards,
Salama Awadallah
Telecom Engineer
Future Technology-Dubai