have tried all I know to resolve
Any one have any ideas?
in OE and reinstalled and deleted .ISM and no luck
Closing UI due to failure to activate Accpac Data Sources
when you do get into OE it shows errors in view and data source
this means
the other workstation's Order Entry has no errors
This workstation, even after copying folder and replacing original folder does not work
I get same error
Hi reinstalled OE, PO,Sys Mgr, did install IC, and now when I go to print in PO it says can not load library..When I try and print in OE,it has no error but does not print pulling Crystal Report nor does it email
Any ideas?
can you suggest a way to check and fix?
also any ideas on why when printing OE and it has no error but does not pull Crystal Reports nor does it pull up email module?
What do mean "advise on checking the datapipe"? What do you want to do? If this PC isn't working the same as the others, then you haven't set it up the same.
FYI, when you reinstall the module, you recreate the xxRPT.INI, so if the datapipe lines were commented out, they're put back in. Recopy the xxRPT.INI files from a PC where it's working.
I can print from the POxx04.rpt but it is not our customized form.
When I try and print our customized form it shut down with UI Container Error stating the memory could not be read
Also when I could print the POxx04. rpt the email module still up
did not pop
up
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.