echo on alog trunks

[Bluebmw330]

Have an issue with echo on alog trunks, have set up as per teh line length measure tool results and it was actually worse.
Also set as per mitel tech support recommendations.

Get bad echo when you hear ringing, and then for 2-3 seconds into call on all calls.
However some calls (20%) continue with echo.

this is across al lines

 

[LoopyLou]

What do you get when you disconnect the controller and use you butt set directly on the trunks.

The beatings will continue until morale improves.

 

[Bluebmw330]

Get no issues with echo at all.

 

[jrgood0852]

Make sure "Audio Inhibit Until Connect" is NO.

 

[danramirez]

Echo on analogues? Run the milliwatt test and you will be fine. There are two ways to doing this, one is when knowing the milliwatt and silence number of your provider, the other one is when you fake the milliwatt by looping back two of your analogues. Procedure is on mOL, if not able to find it please let me know, i have my own guide.

http://www.hatkana.com

http://www.wtelecom.com

 

[Bluebmw330]

Ran the milliwat test etc, and implemented settings, it was actually worse.

 

[danramirez]

Have you contacted Mitel Tech Suppport?

What I don't like is the fact that your trunks have no echo when connected to your butt set.

What did you get after finishing your milliwatt test? Green, Yellow, red? What did you see off your maintenance port?

Are you sure you ran the test correctly?

http://www.hatkana.com

http://www.wtelecom.com