Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

e911 ERL Calls failing on a PRI due to type of number TON: LOCL instead of TON:NATL

Status
Not open for further replies.

markbellot

Vendor
May 18, 2005
70
US
I have a 6.0 system and I am trying to set up e911 to RedSky.


This is a successful call made by dialing direct

DCH 18 UIPE_OMSG CC_SETUP_REQ REF 000012D9 CH 18 13 TOD 9:25:17 CK 58CDFD58
PROGRESS: ORIGINATING END IS NOT ISDN
CALLING #:XXX3122004 NUM PLAN: E164 TON: NATL
CALLED #:1XXX5141715 NUM PLAN: E164 TON: NATL

This is a failed call that goes from ESA to an ERL

DCH 18 UIPE_OMSG CC_SETUP_REQ REF 000012D7 CH 18 16 TOD 9:25:05 CK 58CDA3BD
PROGRESS: ORIGINATING END IS NOT ISDN
CALLING #:XXX3122004 NUM PLAN: E164 TON: NATL
CALLED #:1XXX5141715 NUM PLAN: E164 TON: LOCL


TON is incorrect and AT&T rejects the call. I have a DMI 99 and have tried all of the possible entries for CTYP and that does not make a difference. I am using 811 to test with.

RLI 99
ENTR 0
LTER NO
ROUT 0
TOD 0 ON 1 ON 2 ON 3 ON
4 ON 5 ON 6 ON 7 ON
VNS NO
CNV NO
EXP NO
FRL 0
DMI 99
FCI 0
FSNI 0
SBOC NRR
IDBB DBD
IOHQ NO
OHQ NO
CBQ NO

ISET 0
NALT 5
MFRL 0
OVLL 0

DMI 99
DEL 3
ISPN NO
INST 1XXX5141715
CTYP UKWN

ENTR 1
ESDN 811
ESRT 0
DDGT 811
MISDIAL_PREVENTION YES
MISDIAL_DELAY 3
ALOW_LASTDIG_REPEAT NO
DFCL
OSDN
VOLO_COUNT 0


 
MPLR31577 MPLR30167
ESA 911 call not going through as local since the PSTN requires the
TON to be NPA The DMI is unable to Manipulate the CTYP from LOC
to NPA for ESA calls
 
Your ESA entry 1 is going directly to Route 0 and isn't going thru BARS? There are two ways to setup ESA if I remember, using RLI or Route. Check that out and I will to later (if my old memory remembers!)[pre][/pre]
 
If you out and rebuild your ESA and when you get to ESRT, press ENTER and you should get prompted for the RLI...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top