Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dual Port PRI cable Question

Status
Not open for further replies.

Ski123

Technical User
Mar 21, 2008
239
US
Does anyone know the pin out for a NT5D17AA cable that goes from the front of the NT5D12AA Dual Port PRI Card to the NCTE ? Is it an RJ45 connector on one end? I am trying to connect an NT5D12AA to a Cisco Router.

Thanks
 
Use a Balun to convert the BNC to RJ45. Then you can use a blue/Orange cross over cable.

Cheers

Sean
 
The cable goes from the front of the card to 2 DB-15s on the backplane I/O interface. From there you puck ui up and take it where you want. I think the PBX is a Female DB-15. Pin outs at that point are standard:

1 -----> T Tx Tip to Net
9 -----> R Tx Ring to Net

2 <----> FGND Frame Ground

3 <----- T1 Rx Tip from Net
11 <----- R1 Rx Ring From Net

911Guru
E911 FAQs are located at:
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top