DT-680 Time Display not updating

[kytech2]

Guys,

I just upgraded a NS1000 to 8.32 and installed a couple DT-680 sets and the time on the display does not update until you either press speaker button or lift handset to make call then it updates.

But while phone is idle the time does not update

Anyone seen this?[URL unfurl="true"]https://res.cloudinary.com/engineering-com/image/upload/v1634317602/tips/IMG_0198_x5geku.heic[/url]

 

[obtsystems]

How have you connected DT phones to the NS1000, do you have a cabinet attached or a onenet system

 

[kytech2]

I have a Legacy TDE-200 connected, with a PSU-L and I have updated all station cards to newest firmware

The rest of the sets are KX-DT546, DT343 and they are fine

 

[obtsystems]

Is the legacy gateway cards up-to date too.

I haven’t come across this before

 

[kytech2]

The only cards I have in the TDE are DHLC and DLC and they are at the newest revision, the only card I have not checked to see if there is a newer version is my Stacking card in the NS1000.

 

[kytech2]

Update: after upgrading the firmware on my TDE Stacking card the time issue was corrected.

Thanks for everyone’s input