dbuxton101
IS-IT--Management
I have just found that when putting a 9.x dongle into a IP500v2 chassis that I have previously upgraded to R10 - it doesn't work. In the licensing section its says 'licenced to 8.1' which is not the case.
If I put the same dongle into a chassis that has not been upgraded it works properly. Is there a method of properly downgrading a R10 chassis so the licensing works? Obviously putting the 9.1 dongle in would have downgraded the firmware automatically to 9.1.x
If I put the same dongle into a chassis that has not been upgraded it works properly. Is there a method of properly downgrading a R10 chassis so the licensing works? Obviously putting the 9.1 dongle in would have downgraded the firmware automatically to 9.1.x