I was looking on Avaya's website about connecting my IP Office into an electronic door release. The website showed me the connection to the IP Office; and how to program the short codes, but it never told me how to connect it into the electronic release itself. If looking for a wiring diagram, in case I need another relay or controller. I only need to control one door, in the fail open mode. If anyone can help please let me know. Thank you.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Door Release with IP Office
- Thread starter gcv898
- Start date
If you are interested in sourcing / making your interface,
I think you will find that they use the ring/tip as a dry contact type interface. Low currents are in order (50ma), so you may need it to drive a relay for to operate the 'door release' using external power supply(s).
I think you will find that they use the ring/tip as a dry contact type interface. Low currents are in order (50ma), so you may need it to drive a relay for to operate the 'door release' using external power supply(s).
Check this thread out.
javascript
penindex(450,450,'
"The lack of understanding is the root of all problems
javascript
penindex(450,450,'"The lack of understanding is the root of all problems
Sorry, this is it.
"The lack of understanding is the root of all problems
"The lack of understanding is the root of all problems
- Status
Similar threads
- Locked
- Question
- Locked
- News