Door phone, handicap button conflict 3

[curlycord]

I have this site where two techs seem to mess each other up.

1 tech (ours) installs door phone and works fine

1 tech who installs automatic door with handicap button to open door does his thing then door phone does not work.

We went back to fix now they cannot open the door.


Has anyone ran into this before and know how to sync the two??

Handicap person rolls up to door and press Door Phone button, attendant releases the door strike via code 6, handicap person then press's the big button to open the door.

Our tech is starting to think to have a custom circuit board made up for this.





=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[allworxguy]

Are you using door controller? Get both techs on site at the same time.

Marv

http://www.telemarv.ca

 

[curlycord]

Yes DOC in place.

I have them scheduled but we need ideas if somebody has done this before....would save time.

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[allworxguy]

The door button and the DOC would have to be the same voltage and use one common power supply, they could run in parallel and either would open the door.

Marv

http://www.telemarv.ca

 

[cook1082]

The handy tech disconnected your connection.

 

[jonsjacks]

Set up both units to work off of a dry contact connector then you wouldn't have any conflict.

Jon

 

[curlycord]

Seems DOC is giving 24 AC and theirs was 24 DC

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[norstarboy125]

just a guess buddy but you might need to use 2 DOC.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[2tuff2stop]

Hi I think I ran into a problem like this and the doc and speaker have to be on the same transformer.

Hope this helps