Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Distinct Ring

Status
Not open for further replies.

ptstechnician

Vendor
Jun 28, 2006
895
US
MICS w/7.1 software. Trying to change the Distinct ring on a line (either Target or Trunk). If I change it 2/3 or 4 and go back into programming, its back to default. Any ideas?
 
Curly - My lab switch actually defaulted on its own (after powering it down then up). Still same problem. I don't think its the MICS because I can't get this to work on a customer's MICS (same issue).
 
Yes I have used DR many times and once I applied it to a trunk or HG it would no longer be a option for a end user to pick, but no I haven't had your problem as it always worked for me the way you think it would.

Jeremy J. Carter
Charm City Communications
Norstar. BCM. CS1000 Programmer
 
NTLayoff over at Sundance-communications.com had the answer. I was not hitting next (to save the ring), I was just releasing out of programming.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top