Dial from Asterisk trunk to outside line 2

[digiteltlc]

HNY
I have a sip trunk between Asterisk and IPO500

How can I made a called number from asterisk to pass through IPO500 and dialed to outside line (BRI in this case) ?

Asterisk has an outgoing rule: dial 1234567890 through IPO500 trunk.
When IPO500 receives 1234567890 , it answers back "not found" to asterisk
Obviously 1234567890 dialed from any IPO500 phone is passed regularly to BRI line as outgoing call.

Any hint ?
Thanks.

 

[TouchToneTommy]

Create an incoming call route for the SIP trunk incoming group ID, incoming number is blank, and destination is just a period. This will make the digits received from the SIP trunk act like they are being dialed by a local extension. If you require a dialing prefix on a local extension, like 9-123467890 to call 1234567890, then configure the Asterisk to also send 9-1234567890 to the IP Office

 

[digiteltlc]

Yes, incoming call from a trunk has to be processed by an incoming call route, you're right, my fault.... Thanks.

 

[IPGuru]

just make shure the UCM's Default gateway is the IPO, the IPO should then forward things on corretly.


Do things on the cheap & it will cost you dear

 

[digiteltlc]

Tried just now :

Configured a new incoming call route with Asterisk trunk group ID, no incoming number, period as destination , but no luck :

From = <asterisk_ext_no>@<asterisk_ip_address>, To = 1234567890@<IPO_ip_address>, Answer = 404 Not Found

Any thought ?

 

[tlpeter]

Your sip trunk should have * (wildcard) to accept any number in to the IPO.

BAZINGA!

I'm not insane, my mother had me tested!

 

[digiteltlc]

* wildcard in Local URI, Contact and Display fields does the trick !

Thank you all for infos.