Our sales forces have a customer who has a ancient Enterprise edge 1000. It runs 2.5 s/w. The sales department is recommending dumping the BCM for a new 4.0. They want to know what version or vintage the MBM's are, so they can save the customer money by re-using cards. I am of the belief that you have to actually take the cards out of the BCM to determine this, but I am not sure. Is there another way to accomplish this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Determining version of MBM's in EEdge 1000
- Thread starter Pats14
- Start date
SupportDude
Technical User
IMHO ... its a moot point.
The only MBM I can think of off the top of my head that has not been reworked, enhanced, or re-released is the FEM.
Do you really want to take those old MBM's and install them on a new 4.0 BCM 400?
I'd say you're asking for service calls.
But, you are correct.
You would need to remove the card and check the product label to determine the vintage/version of the MBM.
Good Luck!
-SD-
The only MBM I can think of off the top of my head that has not been reworked, enhanced, or re-released is the FEM.
Do you really want to take those old MBM's and install them on a new 4.0 BCM 400?
I'd say you're asking for service calls.
But, you are correct.
You would need to remove the card and check the product label to determine the vintage/version of the MBM.
Good Luck!
-SD-
- Status
Similar threads
- Locked
- Question
- Locked
- Question