I have an issue with a CX controller showing ASUII ports in the analog forms, but there is no ASUII programmed under the hardware. I believe it is because I restored an MXe database into it and the ASUII was programmed on the MXe's embedded CIM, which the CX does not have. I have had this happen to me before, and I use to log into the telnet(SX2000) side of the controller and I could delete the ASU out of there and everything would work fine. Well, when I do that, the telnet side does not allow me to make any changes via the CDE anymore. Can this be done? Is there different credentials I should be using on the telnet side to accomplish this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Westi on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Deleting an ASUII from a CX controller.
- Thread starter Noods
- Start date
What software? I think in the newest telnet changes are disabled. They did that because people kept accessing telnet to make changes instead of the GUI. Can you not access the ASUII programming in the GUI?
I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.
I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.
- Status
Similar threads
- Locked
- Question
