Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Definity IP issue

Status
Not open for further replies.
Jan 19, 2007
2
US
I have an issue that has completely 'stumped' everyone I know. Here we go!

PBX 1-- IP 192.168.1.30/24
PBX 2-- IP 192.168.23.13/22
Report Server-- IP 192.168.23.230/22

PBX 1 can communicate with all IP's on the 23.0/22 network except the report server.
Report server can communicate with all IP's on the 1.0/24 network except PBX 1.

If I change the IP on Report server, it works. Are there any access-control-lists on the Definity that could be blocking the .230/22 IP?

Any thoughts?

thanks,
skywalker3434
 
Whats in between the subnets hardware wise? Routers and switches or a PIX firewall could all be blocking. I know occasionally in my network we block single IPs because of a virus and then forget to clean it up once the IP is reused. The fact that when you change the IP it works pretty much tells you its not a local firewall on your server or PBX. Has to be an ACL somewhere or a static route for that one IP going to the wrong place or cache that needs to be cleared on the switches. Good luck
 
Adscott,
thanks for the help. We reset the clan board on the PBX and it worked. Since one of the node-names was hard coded to 23.230, it seemed to have caused an issue with network communication. Issue has been resolved!

Thanks for the advice.

skywalker
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top