Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

*DCP 40000000,0,1,2,0 auto answer for external Calls and 9508 IP500 v2 9.0.12 3

Status
Not open for further replies.

nLeo

IS-IT--Management
Nov 19, 2010
193
GB
Howdy all!
using this shortcode on a 9640 works as expected...
with or without an Headset plugged in the call is auto connected.

However on the 9508 is not the case:

Added a button with with
Action: Internal Auto Answer
Action Data: FF

So when Headset light is on the phone auto answers...
when light is off is not .. however on the 9640 it does...

any suggeStions?
 
anyone?

Stuck in a never ending cycle of file copying.
 
anyone?

Stuck in a never ending cycle of file copying.
 
Ferris Beuller?

Stuck in a never ending cycle of file copying.
 
... and absolutely no idea. May have been that way for years.

Stuck in a never ending cycle of file copying.
 
Don't quite get it, it doesn't work at all on 9508 or just not when there's no headset connected?

"Trying is the first step to failure..." - Homer
 
For the 9508 it works as designed as it is "Internal Auto Answer" so it may be a bug in the 9640 firmware or a changed setting in the 46xxsettings.txt:
########## AUTO-ANSWER SETTINGS (H.323 ONLY) #############
##
## AUTOANSSTAT specifies the operation of the local auto-answer capability.
## Value Operation
## 0 Auto-answer is disabled (default).
## 1 Auto-answer is always enabled.
## 2 Auto-answer is enabled if the incoming call is on a primary call appearance.
## 3 Auto-answer is always enabled if the user is logged into a call center.
## 4 Auto-answer is enabled if the user is logged into a call center
## and if the incoming call is on a primary call appearance.
## Note: Auto-answer also depends on the value of AUTOANSSTRING (see below).
## Also, if the call server is administered to provide auto-answer capability,
## the call server administration will take precedence over AUTOANSSTAT.
## This parameter is supported by:
## 96x1 H.323 R6.2.2 and later
## SET AUTOANSSTAT 1
##
## AUTOANSSTRING specifies a substring that must appear in the call-associated
## display message for an incoming call if that call is to be auto-answered.
## If the value of AUTOANSSTRING is null, no substring is required.
## The value can contain 0 to 15 characters; the default value is null ("").
## Note: Auto-answer also depends on the value of AUTOANSSTAT (see above).
## This parameter is supported by:
## 96x1 H.323 R6.2.2 and later
## SET AUTOANSSTRING
##
## AUTOANSALERT specifies whether the telephone will audibly alert for auto-answered calls.
## Value Operation
## 0 Auto-answered calls will not alert (default).
## 1 Auto-answered calls will alert.
## This parameter is supported by:
## 96x1 H.323 R6.2.2 and later
## SET AUTOANSALERT 1
##
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top