We have a CS1000E and CallPilot 600r at our primary site and a remote shelf/cabinet at a secondary site. The two sites are linked via T1 using Nortel SR1001 routers at both ends. We recently lost all voice and fax service at the secondary site. No dial tone - nothing. I had the Telco test the T1, twice, and reported no errors or issues. After some debugging, we found that the Nortel router at the primary site was causing serious packet loss and was not healthy. We replaced that router on Saturday. That immediately brought back dial tone at the secondary site with no more dropped packets.
Issues remain after cleaning up the T1 link:
1. The secondary site can successfully 4-digit dial other users at their site, but no one at the primary site. If they attempt to do so, all they hear is silence after entering the extension and then the call terminates within about 2-3 seconds.
2. They cannot connect to their voicemail. It rings 4 times and then when callpilot picks up the call, again silence and then the call drops within 2-3 seconds. No mailbox and password prompt can be heard.
3. If someone at the primary site enters an extension for someone at the secondary site the phone rings at the secondary site successfully. When the person at the secondary site picks up. Yet again, silence and the call drops quickly.
4. Lastly, anyone attempting to dial an outside number hears silence and then the call drops quickly.
I, like many on these forums, are relatively new to the CS1000. I'm getting familiar with the dot prompt and loading overlays, etc., but still a rookie. If anyone can shed some light on these issues, or give me some things to check, I would greatly appreciate it. Thanks in advance.
Issues remain after cleaning up the T1 link:
1. The secondary site can successfully 4-digit dial other users at their site, but no one at the primary site. If they attempt to do so, all they hear is silence after entering the extension and then the call terminates within about 2-3 seconds.
2. They cannot connect to their voicemail. It rings 4 times and then when callpilot picks up the call, again silence and then the call drops within 2-3 seconds. No mailbox and password prompt can be heard.
3. If someone at the primary site enters an extension for someone at the secondary site the phone rings at the secondary site successfully. When the person at the secondary site picks up. Yet again, silence and the call drops quickly.
4. Lastly, anyone attempting to dial an outside number hears silence and then the call drops quickly.
I, like many on these forums, are relatively new to the CS1000. I'm getting familiar with the dot prompt and loading overlays, etc., but still a rookie. If anyone can shed some light on these issues, or give me some things to check, I would greatly appreciate it. Thanks in advance.