i had tried both the reset botton and the reset using the DTE with no luck. system still hasn't reset and the CPU light still didn"t come back on...what's next??>>>
CPU Board Version is: 0xD0
CPU PLD Version is: 0x17
CPUID: 0x02 Present: 0x0C Present2: 0x02
Using FPGA build 0x00000817
Programming FPGA ...
FPGA ID 0x01 Version 0x01 Build 0x00000817
Initialising NAND device.. registering..
Added device: Hynix 64MB NAND (small block) - 0x0001
P13 Loader v1.3 (SDRAM 128 MB)
MPC8248 CPU Revision 0x0C10
Broadcom Switch Mode was 0x05 now 0x06
EthChipRevId: 0x01 EthPhyId: 0x0143BC30
Erase Main Image Storage Area
OK
that is what shows up and i go through the AT steps and restart but nothing happens. strangly enough if i put the same ip on my laptop as d ipo i am getting an address conflict but wen i change my address and try reaching the ipo i can't even ping it
@amriddle01 i really hope that's not the case right now
yeh it's a feature card mu-law...i have it in as it should be with the serial number facing up...i tried a different card same thing...i actually have a second system where the cpu light is orange and the c/f light flashing greena dn orange.. i think i'm gona give up on the first one... they are both systems that were installed just over a year ago..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.