Connection 2 4450 dss to magix

[joepatt]

Having problem getting the 4424ld+ to recognize the second dss. Have all the correct connectivity and cabling. It will show the second 50 on the first dss but never get lights on the second. Any ideas?

 

[Telecomboy]

Did you program the extension range properly for the second dss? It's been awhile, but I think it's under System Program, start, Sysrenumber, dss.

 

[joepatt]

Programmed second button for page 2. It does not let me program in multiples of 100. I thought it would if you connected a second dss.

 

[TouchToneTommy]

So for instance, did you program them for 100, 200, 300? Or are you trying 100, 150, 200?

 

[joepatt]

Actually they are programmed 50,100.150. Can that be changed to 100,200,300?

 

[dagwoodsystems]

Yes they can!

Tim Alberstein

http://www.dagwoodsystems.com

 

[merlinman]

That's done under "System Renumber".

http://home.comcast.net/~merlinman

 

[joepatt]

I know you can renumber. Does that help with my problem of the second dss not showing lites?

 

[CarGoSki]

You say that the lights don't work on the second dss but do they operate and ring the right phone when a button is pressed?

 

[joepatt]

yes they do if the button below the page 1 button is pressed at the same time as page 1 button. If you press page 2 button nothing on dss2 only on dss1.

 

[merlinman]

OK, it's time to trouble shoot this a bit.

Swap DSS 1 with DSS 2 and see what happens.

Also, we may need to know the RANGE of your extensions.

Perhaps a POWER DOWN and back UP is in order as well.

http://home.comcast.net/~merlinman

 

[joepatt]

Already did all cable and equipment swapping. Things work as previously descrided with any combination. Have considered power down but this is a 24/7 operation. Ext range 700 thru 799.

 

[CarGoSki]

How about that power supply for the phone. Is it hot?
I suppose that if you have swapped out the cabinets and dss 1 always lights while dss 2 does not then it would appear to be a power issue. Perhaps a power cycle could be useful.

I suppose that you could change the cross connect from slot 1 port 1 to slot 1 port 5 on slot one assuming that it is a operator station. This may prove one thing or another.

How about the cabling? Is it four pair all the way through?

 

[joepatt]

Not a power problem already swapped power supply and cable to phone. There is a 1 pr cable from port to power supply. Changing ports is a test option. So far everything I have tried has failed. I have been fighting this issue for 2 weeks.