Hello,
The scenario is like this:
There are three PBXes - A, B and C. There is an IP trunk between A and B using ELU32 which is working perfectly. But between between B and C, the IP trunk isn't working. The same configuration used between A and B was followed but it's not working. All the PBX are running the same service packs and the version of the boards are the same.
In any case, the basic configurations for the trunk that isn't working are as follow:
ROCAI:ROU=21,SEL=0110000000000010,SIG=011110121091,TRAF=00151515,TRM=4,SERV=2010000007,DIST=30,DISL=128,NODG=0,BCAP=001100;
RODAI:ROU=21,TYPE=TL65,VARI=00000001,VARO=00000000,VARC=00000001,FILTER=NO;
RINII:BPOS=5-0-70,GRP=2,IP=ipofPBX,MASK=xmask,ROUTER=xgateway,ETHCNF=0;
RIANI:ROU=21,GRP=2,IP="ipofremotePBX",LROUID="B1",RROUID="C1",CODECS=B-C-2-0-4-1-3-5-6-7-8-9-A;
The ADC at both ends is ADC=16061000000002500060000000
ROEQI:ROU=21,TRU=5-1,IP=ipofPBX;
ROEQI:ROU=21,TRU=5-2,IP=ipofPBX;
ROEQI:ROU=21,TRU=5-3,IP=ipofPBX;
ROEQI:ROU=21,TRU=5-4,IP=ipofPBX;
ROEQI:ROU=21,TRU=5-5,IP=ipofPBX;
ROEQI:ROU=21,TRU=5-6,IP=ipofPBX;
Note that the LROUID and RROUID are swapped at the other end, the GRP at the other end is 2 and the IP address configured to LAN specification at the other end.